Flash-GODOX Photo Equipment Co.,Ltd.

iT30Pro F Firmware V1.02

Release Date

2026/02/11

Remark

1. Please update the firmware with Godox firmware update software Godox G3 version 1.1 or later, which can be downloaded from the official Godox website.
2. How to check the version number:After the device is powered on, go to the menu page and find the device information at the very end. You can see the software version number ( e.g. Version 1.00: V1.00 ).
3. Upgrade method: Method 1.After powering on the device, enter the menu, find the device information, connect the computer via a USB cable, and then click on firmware upgrade. Method 2.In the powered-off state, press and hold the MENU button, then insert the USB interface to connect to the computer and proceed with the upgrade.

Updated Contents

New Features: screen lock power-off memory. support disabling power-on lock in the menu (no unlock required on startup).

Lux Master Firmware V1.02

Release Date

2024/08/01

Remark

Before updating this firmware version, please make sure that your gear has download the G3 firmware launcher installer.

Updated Contents

Improve screen touch.

P2400 Firmware V2.7

Release Date

2026/07/06

Remark

1. Please update the firmware with Godox firmware update software G3. G3 can be downloaded on the official website.
2. How to check the version number: turn on the gear, and press the “MENU” button. The version number is showed at the top right-hand corner of the LCD screen ( e.g. Version 1.0:V1.0 ).
3. Special Notes: If you want to manually adjust parameters including power levels and modeling lamp on the P2400 and prevent transmitters (such as X3, X3Pro and XPROII) from overriding these settings, set the transmitter to L-858 mode by following the steps below: X3/X3Pro: Setting -> Shoot -> L-858, XPROII: MENU -> SHOOT -> L-858. Press and rotate the knob to adjust power levels in full-stop increments.

Updated Contents

1. Optimize the optimal color temperature mode.

2. Add a 2.4G wireless synchronization function to the menu. It can directly synchronize the transmitter’s channel and ID without manual configuration.

3. The default 2.4G channel is revised to 21 to match the transmitter’s default channel.

AD300ProII Firmware V1.05

Release Date

2025/12/22

Remark

1.Please update the firmware with Godox firmware update software Godox G3 Windows V1.1 or Godox G3 MacOS V1.1. Both can be downloaded from the official website.
2.How to check the version number: Turn on the gear, and enter the menu settings to check the version number in Device Info. (e.g., Version 1.1: V1.1).

Updated Contents

1.Adjusted the Mask function (cycle count increased to 8, allowing multiple flash)

2.Fixed an issue when the trigger power level could shift in Color Temperature mode with certain transmitters.

3.Fixed garbled display when decreasing power levels using quick adjustment after disabling wireless groups.

AD100Pro Firmware V1.2

Release Date

2022/08/19

Remark

Before updating this firmware version, please make sure that your gear has download the G3 firmware launcher installer.

Updated Contents

To add compatibility with Flash Trigger for Leica --- XProIIL Wireless System